Ok, set my etka to English and did a search for the part numbers.

6E0 501 465 A = stub axle mounting left from Lupo GTI
6E0 501 466 A = stub axle mounting right from Lupo GTI

6X0 501 117 = stub axle left from Polo 6N2 with drum brakes
6X0 501 118 = stub axle right from Polo 6N2 with drum brakes

357 615 609 = splash shield for brake disc left from Passat 35i b4
357 615 610 = splash shield for brake disc right from Passat 35i b4

N 908 863 01 = hexagon head bolt M10x40 10.9 from Lupo Gti

6Q0 598 611 = wheel bearing with mounting parts from Polo 9N (pcb 5x100)

8N0 615 601 B = brake disc (ventilated) size 256x22 pcb 5x100 from Bora 1,8t 180ps or Golf 4 anniversary or Audi S3 or Golf 4 R32

1J0 615 425 D = brake carrier with pad retaining pin left for Bora 1,8t 180ps or Golf 4 anniversary but NOT S3/4WD/R32
1J0 615 426 D = brake carrier with pad retaining pin right for Bora 1,8t 180ps or Golf 4 anniversary but NOT S3/4WD/R32

N 907 403 01 = screw M10x1,25x30 for fitting brake carrier

1J0 698 451 K = brake pads for disc brakes (set) for Bora 1,8t 180ps or Golf 4 anniversary or Audi S3 or Golf 4 R32

8N0 615 423 C = brake caliper housing left for Bora 1,8t 180ps or Golf 4 anniversary or Audi S3 or Golf 4 R32
8N0 615 424 C = brake caliper housing right for Bora 1,8t 180ps or Golf 4 anniversary or Audi S3 or Golf 4 R32

8E0 611 775 J = brake hose from Passat 4B from year 1999


When car is equipped with ABS an additional ring must be made so the ABS sensor rotor can be mounted to the wheel bearing.
In the first picture of post #66 they used a steel strip to fill the gap so the rotor is tightly attached to the bearing.