16-09-2016, 00:45
|
 |
Forum Regular
|
|
Join Date: Apr 2015
Posts: 131
|
|
Spent the entire day moving the lower hinge on the passenger door, as well as capping off the lower section of the door.
First, I had to modify the mounting pad to angle the hinge
[IMG]
20160915_093612 by Ben Modified, on Flickr[/IMG]
Cut a piece of 3/16" flat bar to weld to the new mount area. Tapped the holes to accept the stock screws.
[IMG]
20160915_150019 by Ben Modified, on Flickr[/IMG]
Then trim up the door to accept the original hinge mount section from the further down door.
[IMG]
20160915_102203 by Ben Modified, on Flickr[/IMG]
The hinge is in place
[IMG]
20160915_150033 by Ben Modified, on Flickr[/IMG]
Cut out a piece of metal to cap off the bottom of the door
[IMG]
20160915_154705 by Ben Modified, on Flickr[/IMG]
Welded in along with a piece of small round bar to give it a blunt edge
[IMG]
20160915_171104 by Ben Modified, on Flickr[/IMG]
Just need to finish off the bottom of the nose where it meets the door and fab a channel on the inside of the door to accept weather strip along the bottom
[IMG]
20160915_173703 by Ben Modified, on Flickr[/IMG]
[IMG]
20160915_173914 by Ben Modified, on Flickr[/IMG]
http://www.BenModified.com
|