ok back from the dead.

this is my new project car. the body work will start soon on it.

OK this is the final version of my Air Suspension. after a few different versions I can post a sort of how to.

the parts list to date:

Koni adjustable struts for the front #8610-1436
1 x 3/8" 150 PSI Hot Rod Economy Front/Back Kit
2 x UVAIR Front Bracket kit for MacPherson
1 x Chapman Universal Strut Kit [NON MAC] $469.94
2 x front bags UVAIR Aero Sport
VIAIR 2" Single Needle Gauge Black Face Illuminated 160psi

Rear lower mount hardware
the jam nuts
the nuts
the bolts 24mmx3x80mm
longer bolts I needed to go higher in the rear 24mmx3x140mm

Front strut housings cut down 52mm to match the shorter koins.






made some adjustable mounts for the bags. the length of the spacer (50mm tubing)










Top mounts and strut bearing mod










Fronts all done ready for install




Rear Setup

Adjustable lower mounts







raised rear towers













The rear beam only goes so far up then it hits the under side of the car. looked at notching the unibody. made some drop plates




Mounting the compressor and tank










the gauges and switches







the valves in the rain tray




The full and vary long story of the build

and the finished product