Thread
:
Fox (that looks like a Golf) Mk1 Wagon
View Single Post
#
64
31-12-2009, 23:16
bannedwagon
Forum Newbee
Join Date: Jun 2007
Posts: 21
Quote:
Originally Posted by
martiepartie
less=more
ok back from the dead.
this is my new project car. the body work will start soon on it.
OK this is the final version of my Air Suspension. after a few different versions I can post a sort of how to.
the parts list to date:
Koni adjustable struts for the front #8610-1436
1 x 3/8" 150 PSI Hot Rod Economy Front/Back Kit
2 x UVAIR Front Bracket kit for MacPherson
1 x Chapman Universal Strut Kit [NON MAC] $469.94
2 x front bags UVAIR Aero Sport
VIAIR 2" Single Needle Gauge Black Face Illuminated 160psi
Rear lower mount hardware
the jam nuts
the nuts
the bolts 24mmx3x80mm
longer bolts I needed to go higher in the rear 24mmx3x140mm
Front strut housings cut down 52mm to match the shorter koins.
made some adjustable mounts for the bags. the length of the spacer (50mm tubing)
Top mounts and strut bearing mod
Fronts all done ready for install
Rear Setup
Adjustable lower mounts
raised rear towers
The rear beam only goes so far up then it hits the under side of the car. looked at notching the unibody. made some drop plates
Mounting the compressor and tank
the gauges and switches
the valves in the rain tray
The full and vary long story of the build
and the finished product
bannedwagon
View Public Profile
Send a private message to bannedwagon
Find all posts by bannedwagon
Add bannedwagon to Your Buddy List